Crucial's site is a good place to look. I checked but don't know what an 
SP6000 is.
http://www.crucial.com/index.asp
Terry

"Graham Butcher" <graham.butcher@dsl.pipex.com> wrote in message 
news:7p6dnVjXmtkK7y_enZ2dnUVZ8t2dnZ2d@pipex.net...
>
> Terry,
>
> You were right, one of the modules was bad and so I now have a hunt to 
> locate another that is compatible as not all Sodimm modules are suitable 
> for Toshiba machines.
>
> Thanks for your help.
>
> Graham.
>
> "tc" <terrycassidy@msn.com> wrote in message 
> news:hKYrf.12676$AP5.2710@edtnps84...
>>
>> Generally these types of errors are caused by faulty ram chips or bad 
>> connections in the ram slots. Take the ram modules out and clean the 
>> connections. Make sure they are firmly seated. If there is more than one 
>> ram module, try each one separately. It might be a module or a slot that 
>> is causing the problems.
>> Terry
>>
>> "Graham Butcher" <graham.butcher@dsl.pipex.com> wrote in message 
>> news:I-KdnbCKktBRpC3enZ2dnUVZ8qadnZ2d@pipex.net...
>>>
>>> I have just aquired a SP6000 which had a faulty screen at first. After 
>>> re-installing Windows XP Pro it worked fine all day but after switching 
>>> off for the night it developed a fault.
>>>
>>>
>>>
>>> Now when switching on it gives the following report, "File ntkrnlmp.exe 
>>> could not be loaded, the error code is 7 (sometimes the code is 14 or 
>>> 4). Setup cannot continue. Press any key to exit.
>>>
>>>
>>>
>>> Sometimes on trying to boot I get a message that reads, Windows cannot 
>>> start because the following file is missing or corrupt, 
>>> "System32\Drivers\PCI.SYS . You can attempt to repair this file by 
>>> starting window set-up  using the original setup CD-ROM.
>>>
>>> Select 'r' at the first screen to start repair.
>>>
>>>
>>>
>>> Using the windows XP disc and slecting boot from CD, the system starts 
>>> to run and then fails with the following message, Windows could not 
>>> start because of an error in the software. Please report this problem as 
>>> "load needed DLLs for Kernal" Please contact your support person to 
>>> report this problem.
>>>
>>>
>>>
>>> On other occasions it will boot up perfectly and on others I get a 
>>> report about some media failed test, check cable, and it will then go 
>>> onto boot OK.
>>>
>>>
>>>
>>> Any help in pin pointing the problem would be greatly appreaciated.
>>>
>>>
>>>
>>> Thanks, Graham
>>>
>>>
>>>
>>
>>
>>
>
>
>